MACHINED IN VAN ALSTYNE, TX  ·  PATENTED BETWEEN-RIB DESIGN BILLET 6061-T6 · ALL-METAL · 3 FINISHES
0

Template.
Mount. Wire.

The whole point of the UBox is what you don't do: no cutting scrap panel into a box, no bending a cover, no making it look right afterward. Here's the entire install.

  • NO FIELD FABRICATION
  • TEMPLATE INCLUDED WITH EVERY BOX
  • STANDARD DECORA DEVICES
01

Trace & cut

Set the supplied template in the flat span between two ribs, trace it, and cut the opening. The template gives you exact lines and screw locations — no measuring, no guesswork.

02

Mount the box

Set the UBox in the opening and drive the supplied fasteners. The body sits square in the span and the faceplate covers your cut edge.

03

Wire & finish

Pull your supply, land your devices, and attach the engraved faceplate. The wall looks factory-finished, and your inspector sees an all-metal box, not a field fab.

Tools

A drill and whatever you already cut panel with. The template supplies the cut lines and screw locations.

Wiring

Supply wiring, device selection, and connection to your electrical system are your electrician's territory — the UBox gives them a proper metallic box to land in. Requirements vary by jurisdiction; when in doubt, ask your inspector and request the spec sheet to show them.

Install questions

Asked with tools in hand

Which panel profiles does the UBox fit?
The UBox mounts in the flat span between the raised ribs of common steel wall panels. Send us your panel brand or profile — or a photo with a tape measure across one span — and we'll confirm fit before you order. The supplied template shows the required flat width.
What's included with each UBox?
The machined box body, the engraved faceplate in your chosen finish, mounting hardware, and the cut template. Add your wiring and devices and the opening is done.
What devices fit it?
Standard decora-style switches, receptacles, dimmers, and inserts — the same devices you'd buy at any supply house. The launch configuration is 2-gang; tell us which configurations you want next.
What tools do I need to install it?
A drill and whatever you already cut panel with. The template supplies the cut lines and screw locations, so there's no layout work.
Ready?

Your next opening takes minutes.

Patented 2-gang electrical box that mounts in the flat span between panel ribs. Machined from billet 6061-T6 aluminum with an engraved faceplate — cut with the supplied template, screw it to the wall, pull your wire.

SHOP THE UBOX